The scale of the problem
The tallest pillars standing at Göbeklitepe (Göbekli Tepe) are the central pair of Enclosure D: about 5.5 m high and, by the excavators' estimate, 8 to 10 metric tons each. The people who set them up had no wheels, no metal tools, no pulleys and no animals to pull for them. Yet they did it many times over, and at sister sites across the Taş Tepeler region as well.
What the quarries show
Here the evidence is unusually good, because the source of the stone is known. The mound sits on a limestone plateau, and the quarry areas are on that same plateau. The rock is bedded in banks between 0.6 and 1.5 m thick, divided by natural fault lines. A quarry worker therefore had to cut around a pillar but not beneath it. Channels were pecked out with flint picks to outline the piece; once the natural parting was reached, the block was most probably prised loose with wooden beams and wedges.
Several pieces went wrong and were left where they lay. The most striking is a T-shaped pillar about 7 m long and 1.5 m thick at the edge of the western plateau, with an estimated weight of around 50 tons. A crack or flaw may have doomed it, or, as the excavators dryly note, the project may simply have been too big.
What is not known
For transport itself, direct traces are absent. No sledge, rope or trackway has survived. The distances are short, from under 100 m to roughly 500 m, but the route runs over uneven bedrock. Reconstructions rest on analogy: timber sledges, plant-fibre ropes, levers, and perhaps timber rails or rollers.
Raising the stone
Setting a pillar upright is a separate problem. The central pillars of Enclosure D stand in shallow sockets cut into bedrock pedestals, which seems too little to hold them unaided. That has been used as an argument for supporting timberwork or a roof. How pillars were tipped into place, with earthen ramps, timber frames or rope teams, is again inferred and not observed.
What would settle it?
Full-scale experiments on the local limestone, with replica flint picks and a sledge on the actual terrain, would turn guesses into measured ranges. Use-wear on quarry tools, drag marks on bedrock exposed under the fill, or preserved timber would be better still. How would you move a ten-ton stone 300 metres with rope and wood? Set out your method, and test it against Logistics and Physics in the game wiki.